Music for the 21st Century
Cart 0

Applying your sign - Five easy steps


When you purchase your sign we will also send you a teflon squeegee to help in the installation.  In addition to this you will need a small bottle of isopropyl alchohol and clean cloth to prepare the window, a pair of scissors and some masking tape.

Step 1

Clean the window where the sign will go with  isopropyl alcohol. Recommended by the vinyl manufacturer, it really cleans the surface and dries very rapidly to allow for an immediate application of the sign.  If you choose to use another cleaner, please let it thoroughly dry.

Clean window with isopropyl alcholoh

Step 2

Place the sign how you want it on the glass and tape it into place top and bottom as shown in the following pictures

place sign

Use the teflon squeegee and lightly go over the carrier paper (the semi-transparent film over the front of the sign vinyl).

smooth out bubbles 

Step 3

Removing the carrier paper and wax paper that sandwich the sign vinyl.

Peel back the carrier paper from one side of the sign as shown below.

begin the peel

Easy does it!

easy does it!

You will notice the sign vinyl comes up with the carrier paper.  If the vinyl sticks to the wax paper, lay the carrier paper back over just enough to cover this part of the vinyl, and gently use the teflon squeegee on the carrier paper side to get the vinyl to stick to the carrier paper rather than the wax paper, and then recommence peeling the carrier paper.

peel back to half way point

When you get to the half way point - roughly where you placed the tape - cut and remove the exposed wax paper as below.use scissors to cut away wax paper

cut all the way

In the picture below the wax paper on the left side has been removed and the left side of the sign is laying over the right side of the sign.

Wax paper removed

Now Lay the carrier paper on to the window glass.  The sign is going on to the glass, so apply the carrier paper evenly to minimize bubbles and wrinkles as below.gently replace carrier paper

Smoothing as you go....

smoothing out carrier paper as it is put back down on the window glass

Step 4

Repeat this process on the other side of the sign.

repeat on right side

peel until the wax paper can be removed.

peel to where wax paper can be removed

Then lay this right side onto the window glass.

lay this side on window glass

.finished with laying carrier paper

Then use the teflon squeegee gently smooth out the carrier paper.  This will ensure the sign vinyl is properly adhering to the window glass.

smooth carrier paper

Step 5

Finally, peel the carrier paper from the glass to reveal your new sign!

peel carrier paper

This is the last step!

Your sign is ready. No special care is needed

finished sign

Get ready for inquiries about your studio.  This form of advertising really works!


If you have any questions please contact us at:



Older Post Newer Post

Leave a comment

Please note, comments must be approved before they are published